ProCurve 420 Manual de usuario descargar pdf (Pagina 9)

Software Management

Due to the increased size of the v2.1.x runtime software file, the access point requires an update of

both the boot code (bootrom306.bin) file and the default software (dflt-img.bin) file. Because the v2.0.x

software does not allow software files of greater than 1.5 Mbytes to be downloaded or the default

software file to be overwritten, a temporary software file must first be downloaded to facilitate the

update.

Note

This update procedure is only for access points running software version v2.0.x. Access points

already running software version v2.1.x or later do not require this procedure.

All the files required for the v2.1.x software update are available from the HP ProCurve Web site (http:/

/www.hp.com/go/hpprocurve). The following table describes the files used in the update procedure.

Version 2.1.x Software Update using TFTP/FTP

Syntax: copy tftp file

The initial v2.0.x to v2.1.x software update can only be performed using the CLI, either through a

direct console connection or Telnet, or using SNMP. The updating of the boot code cannot be

performed using the Web interface.

Note the following points before starting the update procedure:

■ Make sure the access point is running a v2.0.x software version.

■ Place all the v2.1.x update files into the root directory of the TFTP/FTP server.

■ Be sure there is a stable network connection to the access point. If the power to the access point

or the network connection is lost, the update may fail and the access point be unable to boot.

■ Where possible, use a 100 Mbps connection to the access point’s Ethernet port.

Update File Description

hp420-tempimg2.bin The temporary software that is required to allow the access point

to download software files larger than 1.5 Mbytes and update the

default software file.

bootrom306.bin The update boot code that is required for software image files

larger than 1.5 Mbytes to load and run on the access point.

dflt-img.bin The update default software that allows the access point to

download software files larger than 1.5 Mbytes.

hp420-2170.bin The update v2.1.x software.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 36 37

Sin comentarios

ProCurve 420 Manual de usuario Pagina 9