ProCurve 420 Manual de usuario descargar pdf (Pagina 33)

Software Fixes

■ SNMP — Using SNMP management tools, RADIUS server IP addresses

(hpdot11AuthenticationServer of hpdot11AuthenticationTable) can be set to an invalid IP

Address. (18-00262)

■ SNMP — Using SNMP management tools, the Country Code (swCountry of enterpriseApSys

Group) does not show an error when it has already been set (it is allowed to be set only

once). (18-00293)

■ SNMP — Using SNMP management tools, the server IP address (fileServer of enterpriseA-

pFileTransferMgt Group) can be set to an invalid address. (18-00295)

■ SNMP — The portspeedDpxstatus (OID: 1.3.6.1.4.1.11.2.3.7.11.37.3.1.1.8) always shows “half

Duplex 10” even when the value is changed. (18-00332)

■ SNMP — The portflowCtlstatus (OID: 1.3.6.1.4.1.11.2.3.7.11.37.3.1.1.9) always shows “none”

even when a connected switch enables flow control. (18-00333)

■ SNMP — The resetOpCodefile (OID: 1.3.6.1.4.1.11.2.3.7.11.37.5.1) does not check if a file

name already exists, it always accepts the entered value. (18-00334)

■ SNMP — The tree sequence is wrong for hpdot11WepDefaultKey11gEntry (OID:

1.3.6.1.4.1.11.2.3.7.11.37.7.8.1.1.1). (18-00338)

■ SNMP — When using SNMP management tools to download new software, invalid code files

(not hp-img.bin) are not rejected by the access point. (18-00407)

■ TFTP — If using the CLI copy tftp file command and an invalid software code file or TFTP

server IP is specified, the current software code file is deleted before the operation fails.

Note that the “dflt-image” file is not deleted. (18-00231)

■ Encryption — When using WPA Pre-Shared Key mode with some clients that employ power

saving states, the client cannot connect to the access point. This is a compatibility issue with

the client network card and can be solved by disabling power saving on the client. (18-00272)

■ Radio — Regardless of the speed selected via the user interfaces, the access point will always

transmit at the maximum speed rate (11 Mbps for 802.11b and 54 Mbps for 802.11g). (18-

00271, 18-00387)

■ System — After heavy traffic and more than 20 hours of operation, client stations cannot

associate to the access point until it is rebooted. (18-00391)

■ System — When the multicast streaming rate is higher than the multicast-data rate set on

the access point, clients lose association for some minutes. (18-00392, 18-00396)

■ System — The multicast data rate must be set to 1 Mbps in order to operate properly with

Agere based radios. (18-00412)

■ System — The access point only allows MAC addresses on a RADIUS server to be in a

continuous string format. (18-00413)

1 2 ... 28 29 30 31 32 33 34 35 36 37

Sin comentarios

ProCurve 420 Manual de usuario Pagina 33