ProCurve 2610-PWR Información técnica descargar pdf (Pagina 362)

100

101

A-22

File Transfers

Copying Diagnostic Data to a Remote Host, PC, or Unix Workstation

Copying Event Log Output to a Destination Device

This command uses TFTP or Xmodem to copy the Event Log content to a PC

or UNIX workstation on the network.

Syntax: copy event-log tftp < ip-address > < filepath and filename >

copy event-log xmodem

For example, to copy the event log to a PC connected to the switch:

Figure A-9. Example of Sending Event Log Content to a File on an Attached PC

Copying Crash Data Content to a Destination Device

This command uses TFTP or Xmodem to copy the Crash Data content to a PC

or UNIX workstation on the network. You can copy individual slot information

or the master switch information. If you do not specify either, the command

defaults to the master data.

Syntax: copy crash-data [< slot-id | master >] xmodem

copy crash-data [< slot-id | master >] tftp < ip-address > < filename >

where: slot-id = a - h, and retrieves the crash log or crash data from

the processor on the module in the specified slot.

master Retrieves crash log or crash data from the switch’s

chassis processor.

For example, to copy the switch’s crash data to a file in a PC:

Figure A-10. Example of Copying Switch Crash Data Content to a PC

At this point, press

[Enter] and start the

Xmodem command

sequence in your

terminal emulator.

At this point, press

[Enter] and start the

Xmodem command

sequence in your

terminal emulator.

1 2 ... 357 358 359 360 361 362 363 364 365 366 367 ... 468 469

Comentarios a estos manuales

Sin comentarios

ProCurve 2610-PWR Información técnica Pagina 362

Comentarios a estos manuales

Relacionado con productos y manuales para Software ProCurve 2610-PWR