ProCurve 2610-PWR Información técnica descargar pdf (Pagina 319)

100

101

13-37

Configuring for Network Management Applications

LLDP (Link-Layer Discovery Protocol)

Figure 13-16. Example of Per-Port Configuration Display

Configuring Global LLDP Packet Controls

The commands in this section configure the aspects of LLDP operation that

apply the same to all ports in the switch.

Enabling or Disabling LLDP Operation on the Switch. Enabling LLDP

operation (the default) causes the switch to:

■ Use active, LLDP-enabled ports to transmit LLDP packets describing itself

to neighbor devices.

■ Add entries to its neighbors table based on data read from incoming LLDP

advertisements.

For example, to disable LLDP on the switch:

ProCurve(config)# no lldp run

Syntax [ no ] lldp run

Enables or disables LLDP operation on the switch. The no form

of the command, regardless of individual LLDP port

configurations, prevents the switch from transmitting

outbound LLDP advertisements, and causes the switch to drop

all LLDP advertisements received from other devices. The

switch preserves the current LLDP configuration when LLDP

is disabled. After LLDP is disabled, the information in the

LLDP neighbors database remains until it times-out. (Default:

Enabled)

The blank IpAddress field indicates that the

default IP address will be advertised from this

port. (Refer to page 13-42: “Configuring a

Remote Management Address for Outbound

LLDP Advertisements”

1 2 ... 314 315 316 317 318 319 320 321 322 323 324 ... 468 469

Comentarios a estos manuales

Sin comentarios

ProCurve 2610-PWR Información técnica Pagina 319

Comentarios a estos manuales

Relacionado con productos y manuales para Software ProCurve 2610-PWR