ProCurve 2610-PWR Información técnica descargar pdf (Pagina 267)

100

101

12-9

Port Trunking

Port Status and Configuration

• All ports in a trunk must have the same media type and mode (such

as 10/100TX set to 100FDx, or 100FX set to 100FDx). The flow control

settings must also be the same for all ports in a given trunk. To verify

these settings, see “Viewing Port Status and Configuring Port Param-

eters” on page 10-3.

• You can configure the trunk group with up to 8 ports per trunk. If

multiple VLANs are configured, all ports within a trunk will be

assigned to the same VLAN or set of VLANs. (With the 802.1Q VLAN

capability built into the switch, more than one VLAN can be assigned

to a trunk. See the chapter “Port-Based Virtual LANs (VLANs) and

GVRP” in the Advanced Traffic Management Guide.)

(To return a port to a non-trunk status, keep pressing the Space bar

until a blank appears in the highlighted Group value for that port.)

Figure 12-3. Example of the Configuration for a Two-Port Trunk Group

6. Move the cursor to the Type column for the selected port and use the

Space bar to select the trunk type:

– LACP

– Trunk (the default type if you do not specify a type)

All ports in the same trunk group on the same switch must have the same

Type (LACP or Trunk).

7. When you are finished assigning ports to the trunk group, press [Enter],

then [S] (for S

ave) and return to the Main Menu. (It is not necessary to

reboot the switch.)

During the Save process, traffic on the ports configured for trunking will

be delayed for several seconds. If the Spanning Tree Protocol is enabled,

the delay may be up to 30 seconds.

1 2 ... 262 263 264 265 266 267 268 269 270 271 272 ... 468 469

Comentarios a estos manuales

Sin comentarios

ProCurve 2610-PWR Información técnica Pagina 267

Comentarios a estos manuales

Relacionado con productos y manuales para Software ProCurve 2610-PWR