ProCurve 2610-PWR Información técnica descargar pdf (Pagina 336)

ProCurve Stack Management

Configuring Stack Management

Using the CLI To View Stack Status and Configure

Stacking

The CLI enables you to do all of the stacking tasks available through the menu

interface.)

Table 8-6. CLI Commands for Configuring Stacking on a Switch

CLI Command Operation

show stack

[candidates | view | all]

Commander: Shows Commander’s stacking configuration and lists the stack

members and their individual status.

Member: Lists Member’s stacking configuration and status, and the status and the

IP address and subnet mask of the stack Commander.

Options:

candidates: (Commander only) Lists stack Candidates.

view: (Commander only) Lists current stack Members and their individual

status.

all: Lists all stack Commanders, Members and Candidates, with their individual

status.

[no] stack Any Stacking-Capable Switch: Enables or disables stacking on the switch.

Default: Stacking Enabled

[no] stack commander <stack name> Candidate or Commander: Converts a Candidate to a Commander or changes the

stack name of an existing commander.

“No” form eliminates named stack and returns Commander and stack Members

to Candidate status with Auto Join set to No.

“No” form prevents the switch from being discovered as a stacking-capable

switch.

Default: Switch Configured as a Candidate

[no] stack auto-grab Commander: Causes Commander to automatically add to its stack any discovered

Candidate in the subnet that does not have a Manager password and has Auto-

Join set to Yes.

Default: Disabled

Note: If the Commander’s stack already has 15 members, the Candidate cannot

join until an existing member leaves the stack.

8-30

1 2 ... 331 332 333 334 335 336 337 338 339 340 341 ... 363 364

Sin comentarios

ProCurve 2610-PWR Información técnica Pagina 336