ProCurve 2610-PWR Información técnica descargar pdf (Pagina 302)

IP Routing Features

UDP Broadcast Forwarding

Configuring and Enabling UDP Broadcast Forwarding

To configure and enable UDP broadcast forwarding on the switch:

1. Enable routing.

2. Globally enable UDP broadcast forwarding.

3. On a per-VLAN basis, configure a forwarding address and UDP port type

for each type of incoming UDP broadcast you want routed to other VLANs.

Globally Enabling UDP Broadcast Forwarding

Syntax [no] ip udp-bcast-forward

Enables or disables UDP broadcast forwarding on the routing

switch. Routing must be enabled before executing this

command. Using the no form of this command disables any ip

forward protocol udp commands configured in VLANs on the

switch. (Default: Disabled)

Configuring UDP Broadcast Forwarding on Individual VLANs

This command routes an inbound UDP broadcast packet received from a

client on the VLAN to the unicast or broadcast address configured for the UDP

port type.

Syntax [no] ip forward-protocol udp < ip-address > < port-number | port-name >

Used in a VLAN context to configure or remove a server or

broadcast address and its associated UDP port number. You

can configure a maximum of 16 forward-protocol udp assign-

ments in a given VLAN. The switch allows a total of 256

forward-protocol udp assignments across all VLANs. You can

configure UDP broadcast forwarding addresses regardless of

whether UDP broadcast forwarding is globally enabled on the

switch. However, the feature does not operate unless globally

enabled.

— Continued on the next page. —

7-44

1 2 ... 297 298 299 300 301 302 303 304 305 306 307 ... 363 364

Sin comentarios

ProCurve 2610-PWR Información técnica Pagina 302