ProCurve 2510G Series Información técnica descargar pdf (Pagina 159)

100

101

9-7

Time Protocols

SNTP: Viewing, Selecting, and Configuring

ii. Enter the IP address of the SNTP server you want the switch to

use for time synchronization.

Note: This step replaces any previously configured server IP

address. If you will be using backup SNTP servers (requires use

of the CLI), then see “SNTP Unicast Time Polling with Multiple

SNTP Servers” on page 9-21.

iii. Press [v] to move the cursor to the

Server Version field. Enter the

value that matches the SNTP server version running on the device

you specified in the preceding step (step ii). If you are unsure

which version to use, ProCurve recommends leaving this value

at the default setting of

3 and testing SNTP operation to determine

whether any change is necessary.

Note: Using the menu to enter the IP address for an SNTP server

when the switch already has one or more SNTP servers config-

ured causes the switch to delete the primary SNTP server from

the server list and to select a new primary SNTP server from the

IP address(es) in the updated list. For more on this topic, see

“SNTP Unicast Time Polling with Multiple SNTP Servers” on page

9-21.

iv. Press [>] to move the cursor to the Poll Interval field, then go to

step 6.

6. In the Poll Interval field, enter the time in seconds that you want for a Poll

Interval. (For Poll Interval operation, see table 9-1, “SNTP Parameters”,

on page 9-5.)

7. Press [Enter] to return to the Actions line, then [S] (for Save) to enter the

new time protocol configuration in both the startup-config and running-

config files.

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 411 412

Comentarios a estos manuales

Sin comentarios

ProCurve 2510G Series Información técnica Pagina 159

Comentarios a estos manuales