ProCurve 530 Manual de usuario Pagina 1

Cookbook for Configuration of HP WirelessEquipmentBest Practice DocumentProduced by CESNET led working groupon Network monitoring(CBPD125) Authors: To

10 Reset to factory default can be done by keeping the reset key pressed for 5-10 seconds. After the reset, you can log in as admin without any passw

11 Turing the radio on, configuring channel: HP ProCurve Access Point 420(config)#interface wireless g HP ProCurve Access Point 420(if-wireless-g)#c

12 4 HP ProCurve Switches In some cases, running authentication at ports is advantageous. Most state-of-the-art switches fully support

13 Defining VLAN for authenticated and non-authenticated access. We will not assign user ports to any VLAN. vlan 589 name “vutbrno” tagged 26

14 Non-authenticated clients are assigned to the vutbrno VLAN (VID 589) at ports 1 and 3. An authenticated client is correctly connected and assigned

More Best Practice Documents are available at www.terena.org/campus-bp/ [email protected]

2 © TERENA 2010. All rights reserved. Document No: GN3-NA3-T4-CBPD125 Version / date: 24. 03. 2010 Original language

3 Table of Contents Table of Contents 3 Executive Summary 4 1 Cookbook for Configuration of HP Wireless Equipment 5 2 HP ProCurve 530 6 3 HP P

4 Executive Summary This document describes the configuration of access points of the HP ProCurve series. Both the configuration for eduroam authenti

5 1 Cookbook for Configuration of HP Wireless Equipment The examples in this document assume that the following VLANs are attached to the switch po

6 2 HP ProCurve 530 URL at the manufacturer‘s website: http://h10144.www1.hp.com/products/wireless/ProCurve_Access_Point_530/overview.htm The sampl

7 Configuring basic data. In this sample case • Management IP address, default GW, DNS, SNTP • Assigning the management interface to VLAN • Turni

8 ProCurve Access Point 530(radio1-wlan2)# radius-accounting secondary key ProCurve Access Point 530(radio1-wlan2)# radius-accounting secondary ip

9 3 HP ProCurve 420 URL at the manufacturer’s website: http://www.hp.com/rnd/products/wireless/420_series/specs.htm This AP can only broadcast a si